This module is identical to variant TE0841-02-41I21-A except the lower 2.5 mm Samtec connectors.

The Trenz Electronic TE0841-02-41I21-L is an industrial-grade FPGA module integrating a AMD/Xilinx Kintex™ UltraScale™ KU040, 2 GByte DDR4, 64 MByte QSPI Flash for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

Key Features

• AMD/Xilinx Kintex™ UltraScale™ KU040 FPGA XCKU040-1SFVA784I
• Rugged for industrial application
• Size: 40 x 50 mm
• 3 mm mounting holes for skyline heat spreader
• 2 banks of 1024 MByte DDR4 SDRAM, 32bit wide memory interface (each DDR 16bit separate)
• 64 MByte (512 MBit) QSPI Boot Flash
• B2B Connectors: 3 x Razor Beam High-Speed Hermaphroditic Terminal/Socket Strips (low profile 2.5 mm), total 260 terminals
• 60 x HR I/Os
• 84 x HP I/Os
• Serial transceiver: GTH 8 lanes (TX/RX)
• 2 x MGT external clock inputs
• Clocking
  
  • Si5338 - 4 output PLL, GT and PL clocks
  • 200 MHz LVDS oscillator
• Power
  • All power supplies on board, single supply operation supported.
  • User defined IO-Bank power
• Evenly spread supply pins for good signal integrity

Scope of Delivery

• 1 x TE0841-02-41I21-L Trenz Electronic 4 x 5 cm FPGA module with AMD/Xilinx Kintex™ UltraScale™ XCKU040, low profile

Additional Information

• Manufacturer's article number: TE0841-02-41I21-L
• Trenz Electronic TE0841 Wiki
• Samtec LSHM Razor Beam, High-Speed Hermaphroditic Terminal/Socket Strips, low profile 2.5 mm,
  information concerning mating heights: Wiki, mounted on every 4 x 5 cm module from us marked with "LP" or "low profile".
• Support Forum