The TEBA0841 was designed as a low-cost carrier board for Trenz Electronic TE0841 and TE0741 modules. The I/O's of the two FPGA I/O banks can be directly connected to your own circuits with the two 50-pole Pinheaders.

Supported functional range: Wiki Trenz Electronic 4 x 5 cm carrier boards

Features

• Trenz 4 x 5 module socket (3x Samtec LSHM series connectors)
• 1 x XMOD (TE0790) pin header
• 1 x 16-pin header (JTAG, MGT-CLK, Boot Mode, RST, I/O's)
• 1 x 10-pin header (SD I/O's)
• 2 x 50-pin header (FPGA Bank I/O's and Power)
• 1 x SFP connector
• 1 x MicroUSB
• 1 x pin header for FPGA Bank Power VCCIOA (M1.8VOUT, 2.5V, 3.3VOUT)
• 1 x pin header for FPGA Bank Power VCCIOB (M1.8VOUT, 2.5V, 3.3VOUT)
• 1 x pin header for FPGA Bank Power VCCIOC (M1.8VOUT, 2.5V, 3.3VOUT)
• 1 x pin header for FPGA Bank Power VCCIOD (M1.8VOUT, 2.5V, 3.3VOUT)
• 1 x pin header for VBAT (battery connection)
• 1 x LDO Voltage regulator 3.3V to 2.5V
• 1 x dip-switch (bootmode, EN1, MODE, NOSEQ)
• 2 x user LEDs (red/green)

Recommended Hardware

• XMOD FTDI JTAG Adapter (see accessories)
  This adapter is not suitable for the supply of basic board + module; a power supply has to be attached seperately.

Scope of Delivery

• 1 x TEBA0841-02 carrier board
• 2 x Pin Header, straight, double row, 50 pins
• 4 x Jumper

Additional Information

• Manufacturer's article number: TEBA0841-02
• Trenz Electronic TEBA0841 Wiki
• Support Forum