The Trenz Electronic TE0710-02-72I21-A is a FPGA module integrating a Xilinx Artix-7 100T FPGA, two 10/100 MBit Ethernet PHYs, 512 MByte DDR3 SDRAM with 8-bit width, 32 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

Key Features

• Xilinx Artix-7 XC7A100T-2CSG324I FPGA
• Rugged for shock and high vibration
• 256 MBit (32 MByte) Quad-SPI Flash memory
• 100 MHz MEMS oscillator
• 512 MByte DDR3 Memory
• Dual 100 MBit Ethernet PHY
  • MAC Address EEPROM
• On-board high-efficiency DC-DC converters 
  • Core voltage regulator: 4 A

  • 4.0 A x 1.0 V power rail

  • 1.0 A x 1.8 V power rail

  • 1.0 A x 1.5 V power rail

• Power supply: either 3.3 V or 3.3 V and 5 V
• Plug-on module with 2 x 100-pin Razor Beam High-Speed hermaphroditic Terminal/Socket Strips (regular 4 mm)
• Up to 112 (51 differential pairs + 10 single-ended) single-ended FPGA I/O pins available on B2B strips
• 3 LEDs (two status LEDs and one user LED)
• System management and power sequencing
• eFUSE bit-stream encryption
• AES bit-stream encryption
• Evenly spread supply pins for good signal integrity

Scope of Delivery

• 1 x TE0710-02-72I21-A Trenz Electronic 4 x 5 cm FPGA module with Xilinx Artix-7 100T
• 8 x screws
• 4 x bolts

Additional Information

• Manufacturer's article number: TE0710-02-72I21-A
• Trenz Electronic TE0710 Wiki
• Samtec LSHM Razor Beam, High-Speed Hermaphroditic Terminal/Socket Strips, regular 4 mm,
  overview, compatibility, mating heights and speed rating: Wiki, mounted on every 4 x 5 cm module of Trenz Electronic
• Support Forum