The Trenz Electronic TEBB0714 is a base board for test- and evaluation-purposes, especially for the Multi-gigabit transceiver units of the TE0714 module.

This base-board provides also through hole pads for pin headers to get access to the PL I/O-bank pins and further of the mounted Trenz Electronic 3 x 4 SoM.

Features

• Trenz TE0714 Module Socket (2x Samtec 100 Pin LSHM Series Connectors)
• 6-pin header for selecting XMOD/JTAG reference voltage
• One Pin Header 16 pol. (JTAG, MGT-CLK, Boot Mode, XADC, I/O's)
• One Pin Header 10 pol. (I/O's)
• SFP connector (1 MGT Lane, enhanced small form-factor pluggable, supports data transmission rates up to 10 Gbit/s)
• Four Hirose Ultra small SMT coaxial connectors, supports data transmission rates up to 6 Gbit/s
• Two Pin Header 50 pol. (FPGA Bank I/O's and Power)
• One Pin Header for FPGA Bank Power VCCIO34 (1.8 VOUT, 2.5 V, 3.3 VOUT)
• One Pin Header for FPGA Bank Power V_CFG (1.8 VOUT, 2.5 V, 3.3 VOUT)
• One Pin Header for VCCIO34 Power selection
• One LDO voltage regulator 3.3 V to 2.5 V
• Two user LEDs routed to IO-pins of the SoM (Red/Green)
• One LED D3 (red) indicating 'Programming DONE'-signal from module's FPGA
• Soldering-pads J17 and J20 for optional pin headers for access to SoM's IO-bank-pins, usable as LVDS-pairs
• Soldering-pads J3 and J4 for optional pin headers for access to further interfaces and IO's of the SoM

Scope of Delivery

• 1 x TEBB0714-01 Trenz Electronic carrier board for TE0714
• 2 x Pin Header, straight, double row, 50 pins

Additional Information

• Trenz Electronic TEBB0714 Wiki (tba)
• Support Forum